Install Lens - Christie Entero RPMWU User Manual

5.4.2 Install Lens

1. Remove the rear lens cap from the lens. Keep the front lens cap on the lens.
2. Align the lens interface plate with the lens mount. Fully insert the assembly straight into the lens mount
opening without turning. Press using your hand to engage the magnetic lock. NOTICE: Ensure the lens IS
NOT inserted at an angle as this can cause damage.
3. Tighten the yellow lens lock know before fastening the security screws.
4. Fasten the security screws
5. Remove the front lens cap.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(06-2012)
(Figure 5-1). NOTICE: Security screws MUST be installed.
Figure 5-1 Lens Mount
Section 5: Maintenance
5-5