2: Setting Up A Source; Projector Power; Turning The Projector On; Disconnecting The Projector From Ac - Christie Entero RPMWU User Manual

2 Setting Up a Source
This manual assumes that the projectors have been setup, and connected. For detailed hardware installation
and setup instructions, see the Entero Installation Guide.
This section provides information about connecting sources and adjusting source specific image settings.
Illustrations are for reference only and may not depict your projector model exactly.
2.1

Projector Power

• Do not operate if the AC supply and cord are not within the specified voltage and power
range.
• The North American rated line cord is supplied with this projector. For all other regions, use
only a regionally approved line cord, power plug and socket.
• Do not use a damaged line cord.
Directly viewing the LED output with certain optical instruments (for example, eye loupes,
magnifiers and microscopes) within a distance of 100 mm may pose an eye hazard.

2.1.1 Turning the Projector ON

ON
1. Flip the Power switch on the LM (Light Module). The projector takes about 2 minutes to initialize.
2. When the LED display shows 2 dashes and the status light is yellow, press the POWER button, and then
the UP arrow on the remote control.
3. Press one of the Input keys on the remote to select and display the image for the source connected in
Connecting Sources, on page
function, see

2.1.2 Disconnecting the Projector from AC

projector until the cooling fans have stopped.
If you need to check the power connections, an interconnection label is available for reference on the light
module.
1. Stop the projector.
2. After the internal cooling fans stop, move the main power switch on the Light Module to the OFF position.
This gives the Light Module enough time to cool down.
3. Disconnect the line cord from the wall outlet. Refer to
power requirements for the projector.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)
The projector is a class 2M source of visible and invisible LED radiation.
2-2. For more information on the keys available on the remote and their
3.1 Using the IR Remote, on page
Do not turn the main Power switch to the OFF position, or disconnect the
3-1.
Section 7 Specifications
2.2
for complete details on all
2-1