Table of Contents
Advertisement
Install the lens
Failure to comply may result in equipment damage.
• The primary lens seals the projection head, preventing contaminants from entering the
• Lens caps must be removed for operation or they can melt and damage the lens.
1. Make sure the lens locking lever is in the UP position.
2. If attached, remove the rear lens cap from the lens.
3. Slide the lens into the lens mount, aligning all connections
For lenses with an "UP" label, ensure the "UP" label is in the top position. This practice
makes the boresight alignment more consistent each time the lens is replaced.
4. Secure the lens with the lens locking lever (DOWN position).
5. Calibrate the lens motors.
Connect fiber optic cables to the projector
Beam stop must be in the closed position. Failure to comply could result in death or serious
injury.
Failure to comply with the following may result in equipment damage.
• Connect fiber optic cables to the projector once it is securely positioned.
• Secure the tethered protective end cap to the threaded hole in the base of the projector
1. Turn off the laser module breakers.
2. Pull the beam stop knob on the projector and rotate it to closed.
3. If the fiber optic cable comes from the side or the ceiling, loosen 5 mm hex screws (quantity
four) securing the fiber optic stress relief.
4. Rotate the fiber optic stress relief to the correct orientation.
The fiber optic strain relief can be placed in one of four positions: pointing up, down, left, or
right.
5. Secure the fiber optic stress relief.
6. Remove the four screws securing the fiber optic strain relief cover and set the screws and cover
aside.
7. Remove the four screws securing the breakout ferrule and set the screws and ferrule aside.
8. Unlock and open the Optical Access Door.
9. Thread the fiber optic cable through the strain relief into the projector.
10. Remove the tethered cap from the fiber optic cable.
11. Using a fiberscope, inspect the end of the fiber optic connector.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
main electronics area. Do not operate the projector without a lens installed. Use a lens
plug when installing or transporting the projector.
whenever the fiber optic cable is disconnected.
Installation
39
Advertisement
Table of Contents
