Using Inputs And Channels; Inputs; Switching Inputs - Christie Entero RPMWU User Manual

Section 3: Operation
Press E When Finished: To accept edits and leave the edit window, press E
NTER
NOTE: Press E
Edit numerical values: Enter numbers directly from the keypad to specify numbers representing projector
channels (source setups), or slots. As each digit is entered, it is inserted on the right of the field, and the
numbers already in the field are shifted to the left.
Channel numbers are defined with 2 digits—for example, if you enter only a single digit (such as "7") for a
channel number, the channel will automatically be defined as "07". Enter "07" to use this channel. If you press
any non-numbered key, the number entered up to that point is accepted and updated as the new value. Press
E to cancel editing of numerical values.
XIT
3.3

Using Inputs and Channels

The projector allows you to define, store and recalls up to 99 different channels (customized setups or
configurations) for a variety of inputs. Depending on what you have defined, each physical source connection
(i.e., input at the projector) can have several different channels associated with it.
• Slot refers to an input card installed in the projector. There are 4 Input card slots.
• Input refers to both the physical connector on the Input card and to the media source connected to it. Each
Input card can have one or more inputs.
• Channel refers to the setup parameters for a media source input. The parameters include the Slot and Input,
Input type, and Input resolution.
NOTE: See Section 2 Setting Up a

3.3.1 Inputs

An input is a source physically connected to the projector. Input describes the source signal and which input
slot it is connected to.

Switching Inputs

To select an input using the IR remote:
• Press the I
NPUT
slot. The currently selected input for the main image will be highlighted. Scroll up or down through the list
and press E
NTER
for the PIP image. Repeatedly pressing the I
• Press the appropriate SLOT key (1-4) to quickly display one of the 4 Inputs connected to the projector for the
Main image. Press SLOT again to select a different Input. This will not display any menu selection, and is
only applicable for the Main image.
3-10
at any time to cancel changes and return to the previously-defined text.
XIT
Source, for a full explanation of how to connect sources to the projector.
key. This will display a list of the four slots, with the card type and input signal type in each
to make a new selection. Press the I key again to show the list and allow the selection
NPUT
key will toggle between the main and PIP image.
NPUT
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
.
NTER
020-100367-05 Rev. 1 (06-2012)