Christie Entero RPMWU User Manual page 141

(APW) AUTO POWER UP
CONTROL GROUP:
DESCRIPTION
When the A/C switch is turned ON, the projector will automatically change from Stand-by Mode to Power ON
Mode. The projector will switch the lamp(s) on without waiting for further user actions.
SUBCODE
<No Subcode >
EXAMPLES:
(APW 0) - Projector will remain in Standby Mode until the user presses the power key.
(APW 1) - Projector will auto power up when A/C power is switched on.
(ARO) ASPECT RATIO OVERLAY
CONTROL GROUP:
DESCRIPTION
Enables or disables Aspect Ratio layer over Image layer.
SUBCODE
<No Subcode >
EXAMPLES:
(ARO 1) - Turn ON Aspect Ratio Overlay.
(ARO 0) - Turn OFF Aspect Ratio Overlay.
(ASH) AUTO SHUTDOWN
CONTROL GROUP:
DESCRIPTION
When Auto Shutdown Mode has been selected, and no projector activity has been seen for the activation time-out
period, the projector will enter a Power Saving mode in which the lamps will dim and the shutter close. If this
condition persists for an additional time-out period the projector will automatically go to standby. The presence of
any activity within this is combined interval will cancel Auto Shutdown and return the projector to normal
operation.
SUBCODE
<No Subcode >
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(6-2012)
Preference
SUBCLASS:
Unsaved
SUBCLASS:
Saved Power Down
SUBCLASS:
Power Down
ACCESS LEVEL:
DESCRIPTION OF USE
Set to 1 to enable.
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
ACCESS LEVEL:
DESCRIPTION OF USE
Enable or disable Auto Shutdown Operation.
Appendix D: Serial Command Reference
Operator
Operator
Operator
D-7