3.4.6 Secondary Input & Switching
Use the Secondary Input & Switching menu to enable and define how you want to use either the Picture-in-
Picture (PIP) or Picture-by-Picture (PBP) image. Most of the functionality applies the same way when you are
making adjustments to the primary image.
The default is Off until the secondary input source is enabled.
NOTE: To control the primary image, access all picture controls through the Main menu. To control the
secondary image, access picture controls through the Secondary Input & Switching menu.
From the Secondary Input & Switching menu, if you choose either PIP or PBP, you are limited to a
maximum of 60 Hz each.
Main Input
From the list of active Inputs, select one to be used as the Primary or Main image.
Secondary Input
From the list of active inputs, select one to be used as the secondary or PIP.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)
PIP
Figure 3-17 PIP & PBP Example
Main Image
Section 3: Operation
PBP
3-59