Christie Entero RPMWU User Manual page 154

Appendix D: Serial Command Reference
(CNM) CHANNEL INFO: NUMBER
CONTROL GROUP:
DESCRIPTION
This control is used to edit the channel index number.
SUBCODE
C0xx
EXAMPLE:
(CNM+C001 3) - Change the channel number from 1 to 3.
(CON) CONTRAST
CONTROL GROUP:
DESCRIPTION
This control sets the image contrast by adjusting the gain applied to the Input signal. It has exactly the same effect
as adjusting the Input levels, except that it operates an all 3 colors and can be used to make quick adjustments. For
precise control, the Input level adjustments should be used. If the setting is too high, bright portions of the image
that are not quite at peak white are displayed as peak white and detail is lost in the brightest parts of the image.
This condition is known as 'crushing'. If the setting is too low, the image will be dimmer than it need be. Start from
a lower setting and adjust upwards until just below the point where white is crushed.
SUBCODE
INxy
MAIN
PIIP
EXAMPLES:
(CON 500) - Set contrast to 500 on Main video.
(CON+MAIN 500) - Set contrast to 500 on Main video.
(CON+PIIP 250) - Set contrast to 250 on PIP video.
(CON+IN32 100) - Set contrast to 100 on Slot 3, Input 2.
(CON?) - Returns the current contrast value on Main video.
(CON+PIIP ?) - Returns the current contrast value on PIP video.
(CON+IN12 ?) - Returns the current contrast value on Slot 1, Input 2.
D-20
Channel
SUBCLASS:
Input Power Down
SUBCLASS:
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
Select a new number for channel (xx=channel number from 01
to 99).
ACCESS LEVEL:
DESCRIPTION OF USE
Set the contrast on Slot x, Input y to the specified value in the
range of 0-1000.
Set the contrast on the main video to the specified value in the
range 0-1000.
Set the contrast on the PIP video to the specified value in the
range of 0-1000.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
Operator
Operator
020-100367-05 Rev. 1 (6-2012)