Christie Entero RPMWU User Manual page 124

Appendix B: Web UI
To Add a System Event
1. Click Add to open the RTE Wizard.
2. Select the System Event tab.
Figure B-18 Select a type of event from the System Event drop-down list. See
NOTE: Depending on the selection made, additional selections are made available in the second drop-down
list located underneath (i.e. Input Change > Input 1, Slot 1).
To Add a GPIO Event
1. Click Add to open the RTE Wizard.
2. Select the GPIO Event tab.
3. For the GPIO Event option define the Input
Condition field as required. The Input Condition
field contains 7 blocks which refer to the 7 I/O pins
on the GPIO connector. Pin 1 = +12V and Pin 5 =
Ground are not included or changed. 2) Clicking a
block toggles between H, L, and X as shown in
Figure B-20. See
Reference for detailed information.
To Add a Function Key Event
1. Click Add to open the RTE Wizard.
2. Select the Function Key Event tab.
3. Select a Func (function) key from the drop-down
list as shown in Figure B-21. Refer to
Operation for detailed information.
B-12
Figure B-19 Add System Event
Appendix D: Serial Command
Section 3
Figure B-19
Figure B-20 GPIO Event
Figure B-21 Function Key Event
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
.
020-100367-05 Rev. 1 (06-2012)