Christie Entero RPMWU User Manual page 136

Appendix D: Serial Command Reference
(ABL) ARRAY BRIGHT COLOR LOC (Cont'd)
ALBV
DEVC
WENA
WBTH
WGTH
IRTG
DSEL
SKEY
SFRD
AFRD
AFRS
D-2
When set to 1, all projectors in the brightness group
synchronize to this projector's color settings.
0 = OFF
1 = synchronize group
Note: A group can synchronize to only one projector. Setting
ABL+ABLV on any projector in a group to make that projector
the master projector releases the setting from any previous
master projector in the group.
Specifies the ethernet port used for transfer of ColorLOC data.
When selected will use the PHM network ethernet port rather
than default EM network ethernet port.
0 = PHM network
1 = EM network
(FUTURE USE).
Enable warnings associated with Bright/ColorLOC.
0 = disable
1 = enable
(FUTURE USE). Sets the brightness threshold at which a
warning is issued when warnings are enabled. (0-100 percent).
(FUTURE USE). Sets the gamut threshold at which a warning
is issued when warnings are enabled (0-100 percent).
(FUTURE USE). IR Brightness Target. Sets the target
brightness that the projectors in the array brightness group
should meet. (0-1000).
Allows selection of the duty cycle mode of operation:
0 = Automatic
1 = Preset
Synchronize remote control keystrokes, test pattern and color
enable amongst array projectors
0 = Independent
1 = Synchronized
Synchronize frame delay amongst array projectors
0 = Independent
1 = Synchronized
Sets the array frame delay parameter. Applies to all projectors
in array if SFRD is set to Synchronized
Read-only control reports smallest frame delay value in array
that will not generate tearing artifacts
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (6-2012)