Analog Bnc Input Card; Dual Sd/Hd - Sdi Input Card; Video Decoder Input Card - Christie Entero RPMWU User Manual

Section 2: Setting Up a Source

Analog BNC Input Card

This card accepts several types of Sync modes. In 5-wire Sync mode, all 5 BNC connectors are used. If H/C
and V connectors are swapped, this card will still operate normally. An analog graphic source such as a VGA
from a PC can be connected. The card can operate in 4-wire Sync mode, which accommodates 4-wire RGBC
sources. The composite Sync cable can be connected to either the H/C BNC or the V BNC. The card supports
3-wire RGB or YPBPr Sync modes, sometimes called Sync-On-Green (SOG). In this mode the H/C and V
connectors are not used. The Sync is connected to the Green/Y BNC connector. This card offers no loop out
capability. There are 2 LED's on the module faceplate. PWR indicates power has been applied, and the card is
initialized. Signal indicates a valid signal has been detected.

Dual SD/HD - SDI Input Card

This card accepts both standard-definition (SD) and high-definition (HD) serial-digital-interface (SDI) signals
from one of two SD or HD SDI sources. Both single-link HD and dual-link HD signals are accepted. The card
has two SD/HD-SDI outputs, each of which is "loop through" for its respective input. There are three LEDs on
the module faceplate. PWR indicates power has been applied and the card is initialized, and the two signal
LEDs indicate a valid signal has been detected on the respective input.

Video Decoder Input Card

This card accepts and decodes SD video. This includes CVBS (composite video), S-Video, and component
sources. This card supports as many as 6 video signals, four of them on BNC connectors and 2 on 4-pin mini-
DIN connectors. Each mini-DIN connector accepts one S-Video signal. The first BNC accepts composite video
(only), while the remaining 3 BNCs can be grouped to allow one of the following combinations:
• 3 CVBS sources on 4, 5 & 6
• 1 CVBS source, 1 S-Video source: Luma (Y) connected to 4 (Sy) and Chroma (C) connected to 6 (Sc)
• 1 YPbPr source: component signal on 4(Pr), 5(Y) & 6(Pb)
2-4 Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)