Christie Entero RPMWU User Manual page 123

8. Enter a description of the scheduled event in the Description field. NOTE: Maximum of 100 characters.
9. Enter a serial command or a sequence of serial commands, that you want the projector to perform in the
Command String box.
• If a GPIO command string is needed, click the GPIO Output Helper button for instructions on how to
create the command structure. NOTES: 1) The Output field contains 7 blocks which refer to the 7 I/O
pins on the GPIO connector. Pin 1 = +12V and Pin 5 = Ground. These are not included. 2) Clicking a
block toggles between H, L, and X. See Figure B-15 See
detailed information.
• NOTE: The contents of the Serial Representation box (Figure B-14)are read only.
• Click the Help button for a description of special RTE commands available for adding loops and delays
to the command sequence.
• Click the Test button to test the entered command string. NOTE: If the test passed or failed, a green or
red icon appears to the right side of the Test button as shown in Figure B-16.
10. Click Finish to create the added event. NOTES 1) The added event appears in the RTE Listing window.
See Figure B-17. 2) To activate or deactivate one or more RTEs listed in the RTE Listing window, select or
clear each check box in the Active column accordingly.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(06-2012)
Figure B-15 GPIO Output Helper
Figure B-16 Test Buttons
Figure B-17 RTE Listing Window Example
Appendix D: Serial Command Reference
Appendix B: Web UI
for
B-11