Wired Remote; Ir Remote Commands; Power On/Off; Test - Christie Entero RPMWU User Manual

3.1.2 Wired Remote

You can convert the standard IR remote into a wired remote using the optional cable. Connect one end into the
standard IR remote, and the other to the XLR connector labeled Remote on the Electronics Module. The
wired remote is recommended when the lighting conditions are unsuitable for proper IR transmission.
To use the wired remote, make sure that wired remote support is enabled on the projector the remote is
connected to: Main Menu > Configuration > Communications > Wired Keypad Enabled.
To use the wired remote to control multiple projectors in an ArrayLOC network, ensure that wired remote
support is enabled on the controlling projector, and make sure that key synchronization is enabled on the
controlling projector and on all the receiving projectors: Main Menu > Configuration > ArrayLOC >
ArrayLOC Configuration > Synchronize Keys, Test Pattern, Color Enable.
NOTE: Batteries are not required for the wired remote projector control to operate; however, if the laser
pointer is required batteries must be installed in the remote.

3.1.3 IR Remote Commands

Specific keypad commands are explained.
LED output with certain optical instruments (for example, eye loupes, magnifiers and
microscopes) within a distance of 100 mm (3.94") may pose an eye hazard.

Power ON/OFF

Press and hold POWER for 2 seconds or press twice quickly to power the projector ON or OFF. Or, press and
release POWER followed immediately by the UP arrow key (ON) or DOWN arrow key (OFF) to guarantee
that the correct action is initiated. This is useful if you are unsure of the present state of the projector.

Test

Steps forward through all internal test patterns. After stepping past the last test pattern, you will return to
current input. Press TEST and then cycle by using the LEFT or RIGHT arrow keys, to cycle in either direction
through the test patterns. Press EXIT to return to the current input.

Auto

Initiates an automated process in which the projector optimizes critical display parameters such as size,
position, pixel tracking, etc., for the current source. These parameters are listed in Table 3.1. An auto setup can
save time in perfecting a display, and you can modify the adjustments as desired.
Table 3.1 Auto Setup
OPTIMIZES
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)
The projector is a class 2M source of visible LED radiation. Directly viewing the
SETS TO DEFAULT
Contrast
Brightness
Auto Input Level (OFF)
Detail (if video source)
Filter
Luma Delay
Section 3: Operation
3-3