Using The Ir Remote - Christie Entero RPMWU User Manual

3 Operation
This section describes the controls and switches used for basic projector operation once it is properly installed,
aligned, and configured by a Christie accredited service technician. You can access projector controls and
settings with the standard IR remote, or with laptop using the web interface. This chapter focuses on the use of
the remote and the projector menus. For information about access the same functionality through the web
interface, refer to
3.1

Using the IR Remote

directly into the laser beam.
The standard IR remote can be used as a wired or wireless control. Under optimal conditions, the wireless
keypad can communicate with a projector over a 100 foot distance. In wireless mode, the standard IR remote
communicates with the projector with a battery-powered infrared (IR) transmitter.
Use the standard IR remote the same way you would use a remote control supplied with a TV or DVD player.
When pressing a function key, direct the standard IR remote toward the projector's front IR sensor. The IR
sensor on the projector will detect the signal and relay the commands for internal processing. A laser pointer is
built into the standard IR remote. Refer to
Keep these guidelines in mind:
• Press keys one-at-a-time; there are no simultaneous key combinations required.
• NOTE: To use Power, Shutter, and OSD functions, press the appropriate button, and then press the UP
arrow to switch ON or the DOWN arrow to switch OFF: You can also press-and-hold the appropriate button
for 2 seconds, or press it twice quickly. Refer to
• Arrow keys are held down for continuous adjustment/movement in the related key direction.
• NOTE: In serial networks, pause briefly between adjustments to make sure that more distant projectors can
"keep up" with the commands. If you press a key while the projector is still responding to the previous
action, such as during power-up, the second key press may not take effect.
• Refer to 3.1.1 IR Remote, on page 3-2
keypad.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)
Refer to Safety Warnings and Guidelines in 5 Maintenance.
Appendix B: Web User Interface.
Laser radiation is emitted from the laser diode in the remote. Do not look
for the description of those keys provided on the standard IR remote
3.1.1 IR Remote, on page
3.1.1 IR Remote, on page
Section 3: Operation
3-2.
3-2.
3-1