Christie Entero RPMWU User Manual page 71

Test Pattern Enable
Check this option to enable the automatic display of a flat white test pattern when you select the Array
Color Target menu.
The test pattern is turned OFF automatically when you exit the menu.
RGB Brightness Target
Use this option to adjust the RGB brightness target for the array.
Projector Color Adjustment
Use this menu to make ArrayLOC projector-specific color
adjustments. These controls are used to fine-tune the matching
performed by ArrayLOC after the targets have been set through the
Target Color Space menu.
These adjustments compensate for the projection system as a whole,
including loss of brightness or color shift due to lens, mirror or
screen. For example, the mirror might not reflect blue 100 percent,
or the screen might absorb more blue. Measure the output at the
screen with a color meter and use this option to adjust the blue until
you get the array color target value at the screen.
Adjustments are specific to the target color space. If the color space
is changed for the array, projector adjustments can be copied from
the old target color space and fine-tuned again.
Target Color Space
Use this option to change the color space. Changing this option
applies the red/green/blue x/y values associated with the
selected option. It also updates the red/green/blue components
of each color on this menu. Selecting one of the user-defined color spaces displays the last saved
adjustment values.
The Target Color Space option is enabled only on the master projector. All other projector specific color
adjustments on this menu are available on all projectors at all times.
Red Part/Green Part/Blue Part of Each Color
Use these options to make projector specific color adjustments to the selected Target Color Space.
Clear Adjustments
Use this option to reset the color values to the color adjustment default values: 0 or 100.
Reset Current Adjustments To Defaults
Use this option to reset the red part/green part/blue part of each color to the default values set at the factory
during calibration.
Auto Color Enable
Check this option to enable system (background) color to change based on the cursor's position in the
Array Color Target menu.
• Red/green/blue part of red changes the system color to red.
• Red/green/blue part of green changes the system color to green.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)
Section 3: Operation
3-51