Creating A New Channel; Using A Channel; Channel Setup Menu - Christie Entero RPMWU User Manual

Section 3: Operation
NOTE: The C
HANNEL
Channel List" (see Menu Preferences later in this section).

Creating a New Channel

To use a new source with the projector, a new channel must be created so that the projector will respond to an
input signal from that source. A new channel can be created automatically, or it can be copied from an existing
channel and then edited as necessary. See
(S 1, S 2, S
LOT LOT
and signal parameters – this only occurs if Auto Source is enabled on these channels. If no match to the
incoming input signal is found in currently defined channels, a new channel is temporarily created based on
factory-defined defaults for this type of signal. The channel number assigned is the lowest available number
from 01-99.
NOTES: 1) An automatic channel will be discarded unless one or more of its parameters are changed and it
will not appear in the channel list. 2) If 2 channels have the same distinguishing source characteristics except
for the reversal of sync connectors (i.e., H-sync and V-sync, are switched), they are still defined as distinct
channels. 3) You cannot define a new channel without an incoming signal.

Using a Channel

You can normally select a channel from the
Channel Setup list at any time by pressing
the CHANNEL key. If you want to hide a
channel from appearing in this list, you must
deselect the In Menu option (check box - see
IN MENU on page
you wish to access the channel, press the
CHANNEL key and enter its associated
number.
NOTES: 1) The current channel is
highlighted in the channel list, or if the
current channel is hidden, the first channel in
the list is highlighted. 2) Channels created automatically do not appear in the channel list unless a parameter
for the channel was changed. See

Channel Setup Menu

All available channels are listed in the Channel Setup menu, which describes how each channel can be
accessed and provides access for editing, copying and deleting channels Press M
The Channel Setup menu appears.
The far left column lists channel numbers defined in sequential order, unless you have deleted a channel. Refer
to Deleting a Channel, on page
• Horizontal and vertical frequencies, or if there is a defined name for a channel, appear here. The H & V
frequencies will not appear if a name has been defined for the channel; instead only the name is seen. The H
& V frequencies are inserted as the name when the channel is first created. The vertical frequency is
displayed with the sync polarity.
• The remaining columns pertain to each signal type, such as; input number, slot location, a variety of icons
indicating access to each channel, and an abbreviated description of each signal type.
• A Channel Setup Icon legend is provided as a reference.
3-12
key may display a channel list or not, depending on what you have defined for "Display
Copying a Channel, on page
3, or S 4), any existing channels in the projector are searched for matching input
LOT LOT
3-15) for that channel. If
Creating a New Channel on
3-14. The values in the far right columns indicate:
3-14. When you select a direct input
Current Channel#
Channel#
Signal
Horizontal
Slot Type
Frequency
Input
page-3-12.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
TO CHANGE
CHANNEL:
Enter 2 digit
Channel#
Move highlight and
press Enter
Vertical
Frequency
i-Interlaced
p-Progressive
then 3 (Channel Setup).
ENU
020-100367-05 Rev. 1 (06-2012)
or