Christie Entero RPMWU User Manual page 185

(PRT) SERIAL PORT
CONTROL GROUP:
DESCRIPTION
Gets the current serial port being used, or gets a list of serial ports available on the device.
SUBCODE
<No Subcode >
EXAMPLES:
(PRT ?) - Gets current serial port.
(PRT ?L) - Gets list of ports.
(PTL) SERIAL PROTOCOL
CONTROL GROUP:
DESCRIPTION
Set the protocol for a serial communications port.
SUBCODE
PRTA
PRTB
PRTC
EXAMPLES:
(PTL+PRTA 0) - Set protocol on port A to a Christie Digital serial protocol.
(PTL+PRTA 1) - Set protocol on port A to a pass through raw data protocol.
(PTL+PRTA?) - Get protocol (PTL+PRTA!000 "Christie Protocol").
(PVP) PIP VERTICAL POSITION
CONTROL GROUP:
DESCRIPTION
Sets the vertical position of the PIP window. Specifies where to place the center of the PIP window vertically on
the panel in pixels.
SUBCODE
<No Subcode >
EXAMPLES:
(PVP 100) - Set PIP vertical position to 100 pixels.
(PVP?) - Get PIP vertical position (PVP!100).
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(6-2012)
Preference
SUBCLASS:
Preference
SUBCLASS:
Preference
SUBCLASS:
Power Down
ACCESS LEVEL:
DESCRIPTION OF USE
Power Down
ACCESS LEVEL:
DESCRIPTION OF USE
Set the protocol on port A (RS-232 In) pass through
Set the protocol on port B (RS-232 Out).
Set the protocol on port C (RS-422).
Power Down
ACCESS LEVEL:
DESCRIPTION OF USE
Appendix D: Serial Command Reference
Status
Advanced
Operator
D-51