Configuration - Adjusting System Parameters And Advanced Controls; Language; Output Options - Christie Entero RPMWU User Manual

Section 3: Operation

3.4.4 Configuration - Adjusting System Parameters and Advanced Controls

Use the Configuration menu to define general
operating parameters and communications with other
projectors and equipment, and to access other advanced
processing and image adjustments affecting overall
performance. The Configuration menu provides
access to diagnostics, calibration tools and the Service
submenu (password-protected).
The first 6 options in the Configuration menu are
explained below:

Language

Choose the language to use in the projector's menus.
The change will take effect immediately.

Output Options

Screen Image Orientation
Select the on screen image orientation from Front,
Rear, Front Inverted, and Rear Inverted.
Frame Locking
Select how the projector controls the output frame timing based on the input signal. When set to Frame Lock,
output image frames are locked to the input if possible. When locked, the output is always locked to the
primary input, never the PIP image. When set to Free Run, sets the output to the Free Run Frequency value.
NOTE: Frame locking on projectors in a ArrayLOC network can be controlled from one projector. See
Synchronize Frame Delay on
frame delay for the synched projectors in the array.
Set Frame Delay
This control delays the output signal timing relative to the input signal timing by a fraction of a frame, and up
to several frames. The control is only available when the input signal is frame locked. When setting up a
projector array or projector tiling, all projectors should be set to the highest minimum frame delay for the array.
In free run mode, or in cases where the signal cannot be frame locked, the minimum latency reported in Actual
Frame Delay is applied to the signal.
3-30
page-3-55. When Synchronize Frame Delay is used, the master projector sets the
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)