Christie Entero RPMWU User Manual page 199

(STD) VIDEO STANDARD (Cont'd)
PIIP
EXAMPLES:
(STD 0) - Set video standard to 0 (PAL) on main video.
(STD+MAIN 1) - Set video standard to 1(NTSC_M) on main video.
(STD+PIIP 0) - Set video standard to 0(PAL) on PIP video.
(STD+IN32 3) - Set video standard to 3(NTSC_4_43) on Slot 3 Input 2.
(STD ?) - Returns the current video standard on main video.
(STD+PIIP ?) - Returns the current video standard value on PIP video.
(STD+IN12 ?) - Returns the current video standard value on Slot 1 Input 2.
(SZP) SIZE PRESETS
CONTROL GROUP:
DESCRIPTION
Sets the image to one of several preset size/position presets.
0 = Default
1 = None
2 = Full Screen
SUBCODE
<No Subcode >
EXAMPLES:
(SZP 1) - Set the size preset to no resizing.
(TBL) TOP BLANKING
CONTROL GROUP:
DESCRIPTION
Set the number of lines to blank (turn to black) at the top of the image. This can be used to blank out any unwanted
data near the top edge of the image.
A positive amount of blanking makes the image smaller. A negative amount of blanking makes the image larger.
Negative blanking is only applicable to analog signals, when the auto setup has not been able to set the image size
correctly. It is preferable not to use negative blanking, but to run auto setup again, ensuring that the content has
active pixels on each edge of the image.
The maximum amount of top blanking allowed is half the image height minus 10. For negative blanking, the
image size can only be increased to the limit of the sync.
SUBCODE
INxy
MAIN
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(6-2012)
Unsaved
SUBCLASS:
3 = Full Width
4 = Full Height
Input Power Down
SUBCLASS:
Set the video standard on the PIP video to the specified value
in the range of known video standards.
Power Up
ACCESS LEVEL:
5 = Anamorphic
6 = Custom
DESCRIPTION OF USE
ACCESS LEVEL:
DESCRIPTION OF USE
Set the top blanking for Slot x, Input y.
Set the top blanking for the main image.
Appendix D: Serial Command Reference
Operator
Operator
D-65