Display Is "Noisy; Arrayloc; Cannot Find Color Adjustment Controls; Color/Image Settings Are Greyed Out - Christie Entero RPMWU User Manual

6.5.12 Display Is "Noisy"

1. Display adjustment at the input source may be required. Adjust pixel tracking, phase and filter. Noise is
very common on YPbPr signals from a DVD player.
2. Make Sure the video input is terminated (75 ohms). If it is the last connection in a loop-through chain, the
video input must be terminated at the last source input only.
3. The input signal and/or signal cables carrying the input signal may be of poor quality.
4. If the distance between the input source device and the projector is greater than 25 feet, signal
amplification/conditioning may be required.
5. If the source is a VCR or off-air broadcast, detail may be set too high.
6.6

ArrayLOC

6.6.1 Cannot Find Color Adjustment Controls

Use the color adjustment options under the ArrayLOC menu: access Main menu > Configuration >
ArrayLOC. Color Adjustments by X,Y and Color Saturation options are not available for general use. They
are part of the passcode protected Service menu.

6.6.2 Color/Image Settings Are Greyed Out

To enable ArrayLOC: access Main menu > Configuration > ArrayLOC > Bright/ColorLOC Mode and set
to Fixed, Cool, or Bright.
If ArrayLOC is enabled:
• ArrayLOC handles brightness and color settings, and overrides other color settings, for example Advanced
Image Settings > Color Settings.
• Main menu > Configuration > ArrayLOC > Array Color Target color settings are available for the
master projector and are greyed out for all other projectors. To make your projector the master: access Main
menu > Configuration > ArrayLOC > Synchronize to This Projector. Any projector in the array or BC
group can be the master. The last projector to be set as the master is the master for the array (All) or BC
group (Group). This setting is not saved between session.

6.6.3 Sensor Isn't Calibrated (Yellow Alert)

Sensor calibration must be performed by Christie accredited service technicians. Contact Customer Support.

6.6.4 Invalid Target Gamut (Yellow Alert)

A color setting is not valid for the current color space, for example a white point is outside of the gamut.
1. Access the Array Color Target menu: Main > Configuration > ArrayLOC > Array Color Target.
2. Check XY settings for the colors.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(06-2012)
Section 6: Troubleshooting
6-7