Christie Entero RPMWU User Manual page 114

Appendix B: Web UI
3. Click the Login button. The Main window (see Figure B-3) appears.
D
C
B
A
The following table describes each area found in the Main window. See Figure B-3.
Secondary Tabs (specific to a
A
primary tab) located along the
bottom of the Main window.
Primary Tabs located along the
D
top of the Main window.
Status Indicator displays the
G
overall status of the projector,
based on the 12 categories of
information available. NOTE:
Click the Status Indicator LED
to display the Status window
and obtain more information
about any current errors and
warnings. See Section B.3.2
Main Tab - Status.
Shutter section contains an
J
Open and Close button. Only
one is enabled depending on the
current state of the projector's
shutter.
B-2
E
Figure B-3 Main window
PIP Active Input Window and
B
Main Active Input Window
sections are read-only.
Current Status Bar provides
E
information messages according
to the current status of the
projector.
Logout button (located at the top
H
right corner of the web browser)
is used to logout you off of the
web user interface and the
projector.
OSD (On Screen Display)
K
section contains an On and Off
button. Only one is enabled
depending on the current state of
the projector's on-screen display.
F G H
These sections provide drop-
C
down list selections (refer to
Section 3, Operation for more
details).
Projector Information section
F
is read-only.
Power section contains an On
I
and Off button. Only one is
enabled depending on the
current powered state of the
projector.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
I
J
K
020-100367-05 Rev. 1 (06-2012)