Dvi Digital Video; Dual Link Dvi Input Card; Twin Hdmi Input Card - Christie Entero RPMWU User Manual

DVI Digital Video

• Use the DVI-I connector to connect either analog or digital video devices to the projector. Use a cable with
DVI-I connectors at both ends to connect devices that transmit digital and analog video signals such as high-
quality DVD players, satellite receivers and digital cable TVs.
• NOTE: For true digital output from devices that transmit digital signals, connect to the DVI-I connector.

Dual Link DVI Input Card

This card accepts a single DVI signal over a DVI-I connector and analog video signals over the DVI-I or 15-
pin VGA connector. The module can simultaneously support a digital signal on the DVI input and an analog
signal on the VGA port; however it does not support 2 analog signals at the same time. There are 4 LEDs on
the module faceplate. PWR indicates that power is applied and the card is initialized, and the other three LEDs
on the right-side of the corresponding connectors indicate that a valid signal has been detected.

Twin HDMI Input Card

This card accepts 1 or 2 HDMI inputs, and can route one or both inputs to the card's outputs. Any input from
any card can be looped out of this card. The output label 1-OUT loops out the main image being displayed on
the projector. The output labelled 2-OUT loops out the image displayed in the picture-in-picture (PIP). Any
input from any optional input card can be looped out of this card.
There are 5 LEDs on the module faceplate. The PWR LED on the left side indicates power is applied, and that
the card is initialized. The LEDs to the right side of the corresponding connectors indicate that a valid signal is
detected. In the case of the outputs, the LED indicates that a signal is currently being looped out.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(06-2012)
Section 2: Setting Up a Source
2-3