Christie Entero RPMWU User Manual page 58

Section 3: Operation
NOTE: The corner cursors are a guide as to how the image will be adjusted. The outside edge of a cursor
will be the outside edge of the image. It may not be possible to exactly match the screen dimensions with
the Horizontal and Vertical Keystone controls, but these settings can be refined when the 2D keystone
settings are adjusted.
4. When adjustment of the corners is complete, select OK.
NOTE: A message displays indicating that the projector is "Processing request". The settings are
applied to the displayed image, and will take approximately 10 seconds.
5. After the Horizontal or Vertical adjustments have been made, selecting Adjust 2D Keystone will retain
these settings. Fine adjustment can now be made by moving any single corner separately.
6. Use the arrow keys to select the required corner. NOTE: The current corner is displayed in red.
7. Press E
NTER
8. Use the arrow keys to move the selected corner to match the screen.
9. Press E
NTER
10. Repeat Steps 6 to 9 to adjust all 4 corners until they match the screen.
11. Select OK to apply the new corner positions to the image.
NOTE: A message displays for approximately 10 seconds indicating that the projector is "Processing
request".
12. Under certain combinations of extreme keystone co-ordinates and specific signal frequency, a keystoned
image may result that is outside the bandwidth limitations of the projector. When attempting to apply the
keystone settings, a message will pop up on the OSD, indicating that the bandwidth has been exceeded and
3-38
to activate the corner adjustment. NOTE: The current corner is displayed in green.
again, to save that position for the corner.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)