Arrayloc Troubleshooting Tree Continued - Array Brightness Setup - Christie Entero RPMWU User Manual

Section 6: Troubleshooting Tree

6.6.7 ArrayLOC Troubleshooting Tree Continued - Array Brightness Setup

Troubleshooting ArrayLOC -
START HERE
Go to the Main > Configuration (4) > ArrayLOC (13) >
Bright/ColorLOC Configuration (3) menu.
Select the Array Status menu item to display the
Bright/ColorLOC Array Status.
Do the colors and brightness of
the array projectors match?
Yes
Is the array brightness the
expected brightness?
Yes
Are the array colors (red, green,
blue, white) the expected colors?
6-10
A3 B4 C7 C8 C9
B1 C3 C12
Menu
Reference
A11
A7 B2
A1
No
B1
No
C1
No
Bright/ColorLOC Array Status
4 Target Gamut 800 330 160 800
< Target Common Gamut 687 306 193 738
Flags ProjID Group Int Age Rx Ry RY Gx Gy
W 1 211 1 1 692 304 283.2 185 748 696.8 139 28
r wW* 0 211 1 1 687 306 109.9 193 741 123.4 145 23
W 2 211 1 1 699 296 416.5 188 745 778.5 141 29
gbW 3 211 1 1 700 295 343.7 181 749 700.9 149 23
Menu > Configuration > ArrayLOC > Projector Color Adjustment
Menu > Configuration > ArrayLOC > Array Color Target
Menu > Configuration > ArrayLOC > ArrayLOC Configuration
A12 A13
Menu > Configuration > ArrayLOC > Bright/ColorLOC Configuration
B1
Is the RGB Brightness
Is it higher than the projector's
white brightness capabilities?
B2
125 000 313 329 1000
150 34 313 329 350
setting appropriate?
GY Bx By BY Wx Wy WY
67.2 313 329 369.1
B3
17.9 313 329 361.2
Are there any projectors
91.7 313 329 418.0
with excessively low white
brightness capabilities?
57.3 313 329 390.5
Check lens for dust / dirt
Check screen gain
A5
Menu > Status
C11
Menu > Configuration > Service > Color Saturation
C10
Menu > Configuration > Service > Advanced Color Adjustment
A14 C4
Menu > Configuration > Service > ArrayLOC Service
Proceed to Fine
Tuning of Projected
Colors (Managing
Colors with ArrayLOC
in Section 3)
Proceed to Take
Control of the Array/
Set the Array Color
Target (Managing
Colors with ArrayLOC
in Section 3)
No
B1
Note!
The unit of the RGB Brightness
Target correct?
Target value can be set using the
PCA "White Brightness
Adjustment".
See "Setting the RGB
Brightness Target Unit"
Yes
B2
Note!
No
Unless the array is being
Is the array
deliberately dimmed, the
RGB Brightness RGB Brightness (NOT the
RGB Brightness Target)
should be set to 100.
Yes C5
B4 Yes No
Does increasing the
White Brightness Adjustment
Yes
on the problem projectors
improve their performance?
No
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev.1 (06-2012)