Christie Entero RPMWU User Manual page 186

Appendix D: Serial Command Reference
(PWR) POWER
CONTROL GROUP:
DESCRIPTION
Change the power state of the projector.
Valid values are:
0 - Power-OFF
1 - Power-ON
10 - Cooldown lamp is cooling down, controlled by lamp (Read-only)
11 - Warmup lamp is warming up, controlled by lamp (Read-only)
SUBCODE
<No Subcode >
EXAMPLES:
(PWR?) - Get projector power status.
(PWR1) - Turn the lamp and all electrical power ON.
(PWR0) - Set the projector to standby mode.
(PXP) PIXEL PHASE
CONTROL GROUP:
DESCRIPTION
Pixel Phase adjusts the phase of the pixel sampling clock relative to the incoming signal. This allows you to fine
tune the sampling point within one pixel. Adjust the Pixel Phase when the image (usually from an RGB source)
shows shimmer. NOTE: If the shimmer is concentrated in vertical bands with little or no shimmer between the
bands, then it is likely that Pixel Tracking needs adjustment. Pixel Tracking must be set correctly before adjusting
Pixel Phase. Pixel Phase can only be set on Analog Input cards. The range is 0-31.
SUBCODE
INxy
MAIN
PIIP
EXAMPLES:
(PXP 16) - Set pixel phase to 16 on main video.
(PXP+MAIN 16) - Set pixel phase to 16 on main video.
(PXP+PIIP 16) - Set pixel phase to 16 on PIP video.
(PXP+IN32 16) - Set pixel phase to 16 on Slot 3, Input 2.
(PXP?) - Returns the pixel phase value on main video.
(PXP+PIIP?) - Returns the pixel phase value on PIP video.
(PXP+IN12?) - Returns the pixel phase value on Slot 1, Input 2.
D-52
Unsaved
SUBCLASS:
Input Power
SUBCLASS:
Power Down
ACCESS LEVEL:
DESCRIPTION OF USE
Get or Set the power state of the projector.
Down
ACCESS LEVEL:
DESCRIPTION OF USE
Set the pixel phase for Slot x, Input y.
Set the pixel phase for the main image.
Set the pixel phase for the PIP image.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
Operator
Operator
020-100367-05 Rev. 1 (6-2012)