Advanced Tabbed Page - Rte; Rte Buttons - Christie Entero RPMWU User Manual

Appendix B: Web UI
B.3.6 Advanced Tabbed Page - RTE
The RTE (Real-Time Events) tab is where you can manage real-time events (i.e. add, delete, edit, copy and
setup the GPIO) as described in the following section.

RTE Buttons

The real-time event buttons include the following:
• Add, create a new event
• Delete, remove one or multiple existing events
• Delete All, remove all events
• Edit, change or add information for an existing event
• Copy, clone an existing event
• Stop, discontinue the event running
• GPIO Setup, used to configure the GPIO pins as inputs/outputs and to set the current state of the output pins
To Add a Scheduled Event
Scheduled events include a command or sequence of commands, for example, (PWR1) or (PWR1) (SHU1).
1. Click Add to open the RTE Wizard.
2. Select the Scheduled Event tab. NOTE: The scheduled tab is always selected by default on add.
3. Select the frequency option for the event by selecting either Once, Daily, Weekly, or Monthly.
NOTE: End Date is enabled when Daily, Weekly or Monthly repeat options are selected.
NOTE: Depending on the frequency option you select, the Repeat Every option may be highlighted on the
tab. Use this area to enter the frequency of each event.
4. Click within the Start Time field to open a calendar pop-up window.
5. Navigate to and choose a desired date. The selected date will populate the Start Time field.
6. In the field below the Start Time field, enter a start time in the format "hr:min:sec". The default is the
current time.
7. Click Sync to set the computer and projector time to be the same; otherwise, the event will run based on
the projector time.
B-10
Figure B-14 Scheduled Event Window
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)