Christie Entero RPMWU User Manual page 182

Appendix D: Serial Command Reference
(PDT) PEAK DETECTOR
CONTROL GROUP:
DESCRIPTION
Enables or disables the peak detector test mode. This is used to aid in setup of Input levels. For each color, pixel
values very near black will be displayed black, pixel values very near peak level will be displayed full on. All
others will be displayed in mid-level grey. Input levels for each color should be adjusted so that black pixels in the
image just turn black, and full on pixels just turn full ON. When adjustment is completed this control should be
disabled to allow display of all grey levels. This control takes place before the scaler/deinterlacer.
SUBCODE
<No Subcode >
EXAMPLES:
(PDT 1) - Turn ON peak detector.
(PDT 0) - Turn OFF peak detector.
(PHP) PIP HORIZONTAL POSITION
CONTROL GROUP:
DESCRIPTION
Sets the horizontal position of the PIP window. Specifies where to place the center of the PIP window horizontally
on the panel in pixels.
SUBCODE
<No Subcode >
EXAMPLES:
(PHP 100) - Set PIP horizontal position to 100 pixels.
(PHP?) - Get PIP horizontal position ((PHP!100), for example).
(PHS) PIP HORIZONTAL SIZE
CONTROL GROUP:
DESCRIPTION
Sets the size (width) of the PIP window in pixels. The active portion of the Input signal, as determined by
blanking controls, will be scaled to fit into the PIP window. The height of the PIP window will be set to maintain
the aspect ratio of the image being captured, as determined by the vertical stretch control.
SUBCODE
<No Subcode >
EXAMPLES:
(PHS 100) - Set PIP size to 100 pixels.
(PHS?) - Get PIP size ((PHS!100), for example).
D-48
Unsaved
SUBCLASS:
Preference
SUBCLASS:
Preference
SUBCLASS:
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
Operator
Operator
Operator
020-100367-05 Rev. 1 (6-2012)