Christie Entero RPMWU User Manual page 149

(BRT) BRIGHTNESS (Cont'd)
MAIN
PIIP
EXAMPLES:
(BRT 500) - Set brightness to 500 on main video
(BRT+MAIN 500) - Set brightness to 500 on main video.
(BRT+PIIP -250) - Set brightness to -250 on PIP video.
(BRT+IN32 100) - Set brightness to 100 on Slot 3, Input 2.
(BRT?) - Returns the current brightness value on main video.
(BRT+PIIP ?) - Returns the current brightness value on PIP video.
(BRT+IN12 ?) - Returns the current brightness value on Slot 1, Input 2.
(BRU) BRIGHTNESS UNIFORMITY
CONTROL GROUP:
DESCRIPTION
Enable/Disable brightness uniformity and adjust brightness uniformity output.
SUBCODE
SLCT
CRSA
UITL
UIML
UIBL
UITR
UIMR
UIBR
UIH1
UIH2
UI1P
UI2P
GAIN
UIRT
EXAMPLES:
(BRU+SLCT?) - Get current state of brightness uniformity, 0 is disabled, 1 is enabled.
(BRU+SLCT 1) - Enable brightness uniformity.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(6-2012)
Preference
SUBCLASS:
Set the brightness on the main video to the specified value in
the range -1000 to 1000.
Set the brightness on the PIP video to the specified value in the
range of -1000 to 1000.
Power Down
ACCESS LEVEL:
DESCRIPTION OF USE
Enable/Disable Brightness Uniformity.
Enable/Disable BRU Coarse Adjustment.
Get/Set the percent of gain at top left corner.
Get/Set the percent of gain at left side.
Get/Set the percent of gain at bottom left corner.
Get/Set the percent of gain at top right corner.
Get/Set the percent of gain at right side.
Get/Set the percent of gain at bottom right corner.
Get/Set the percent of gain at left turn point.
Get/Set the percent of gain at right turn point.
Get/Set position of left turn point.
Get/Set position of right turn point.
Get/Set overall gain.
Restore all parameters to factory default.
Appendix D: Serial Command Reference
Operator
D-15