Swap Main & Secondary Inputs; Pip Enable; Pip Window Options - Christie Entero RPMWU User Manual

Section 3: Operation
Swap Main & Secondary inputs
Toggle the current secondary input's relationship so that the primary (Main) input becomes the secondary, and
the secondary input becomes the primary. Swapping is available only when PIP or PBP is enabled.
NOTE: There may be a slight delay when swapping the Primary and Secondary images.

PIP Enable

Use this option to enabled a secondary image.
OFF displays the main input source only.
PICTURE-IN-PICTURE displays the 2 inputs at
once, one image in a window in the other image.
PICTURE-BY-PICTURE displays 2 inputs at
once, side by side.
Short cut: Press PIP on the IR remote to toggle
between displaying 2 input sources at once (main and secondary images) or the primary or main input source
only.

PIP Window Options

Set the location of the PIP (secondary) image in the display. You can adjust the following:
PIP Position Presets
Set the location of the PIP (secondary) image in the display.
PIP Window Size
Controls both the image width and height in tandem, maintaining
the current aspect ratio of the displayed signal data.
PIP H-Position
Moves the image right or left within the area of available pixels.
NOTE: The value shown represents where the approximate center of the image lies in relation to the total
number of pixels available horizontally. This varies widely according to the signal; watch the image while
adjusting.
PIP V-Position
Moves the image up or down within the area of available pixels.
NOTE: The value shown represents where the approximate center of the image lies in relation to the total
number of pixels available Vertically. This varies widely according to the signal; watch the image while
adjusting.
PIP Border Width
Enables the optional border around the PIP image. When enabled, a one pixel-wide border will surround the
PIP image. When disabled, no border will be displayed.
PIP Border Color
This control allows you to choose the color of the optional border around the picture-in-picture image. The
border can be disabled by setting the width to zero.
3-60
Figure 3-18 Picture-In-Picture
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)