Communications - Christie Entero RPMWU User Manual

Section 3: Operation

Communications

Defines and controls how single or multiple projectors
are linked with each other and to a controlling device.
For detailed information, see
C-1.
Serial Options
NOTE: The Synchronize Keys, Test Pattern, Color
Enable option lets you use the ArrayLOC network to
forward IR remote keys from the master projector to all
the synched projectors in the ArrayLOC group. See
Synchronize Keys, Test Pattern, Color Enable on
page-3-54.
Baud Rate
Determines the speed of communication to and from the projector on the RS-232 or RS-422 links. The
maximum rate for the RS-232 is 115200; for RS-422 it is 19200. Set the baud rate to match that of your
controlling device, such as your PC. Refer to the documentation for the controlling device to determine the
baud rate. In an existing network of projectors, if you discover that a projector has a different baud rate, use
the drop-down list and select the correct baud rate using the E
L arrow key or R
EFT
Serial Flow Control
Determines whether software flow control or no flow control is
used when transmitting and receiving data on the serial port.
Serial Mode
Select the serial data mode. The mode includes the number of
bits, the parity and the number of stop bits.
Serial Protocol
Select the protocol used on the serial communications port.
Projector Address
Enter a number up to 3 digits in length (such as "001") to assign or change a number to the projector currently
in use. If the current projector already has a number assigned, that number will appear here. Numerical identity
for projectors enables you to communicate with a single projector within a multiple-projector application (see
also P key described in
ROJ
changing the projector number, press E
NOTE: When multiple projectors are being used and you want to adjust the color for individual projectors to
create a seamless image, you must assign different numbers for each projector to allow switching back and
forth between them while adjustments are being made.
3-34
C.1 Introduction, on page
arrow key. Serial communication is always 8 data bits, no parity.
IGHT
3.1 Using the IR Remote, on page
to cancel.
XIT
key. DO NOT scroll this control with
NTER
3-1). If you make a mistake in assigning or
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)