Shutter; Function Key; Proj; Enter - Christie Entero RPMWU User Manual

Section 3: Operation

Shutter

The shutter is open upon power-up. Press and hold SHUTTER to move between simulated shutter states in the
order; OPEN-CLOSED-WHITE-OPEN. Or, press and release SHUTTER followed immediately by UP arrow
key (Closed) or DOWN arrow key (Open) to guarantee the correct state.
Close the shutter to block the displayed image while maintaining access to projector functions.
The white shutter state allows you to view menus and images if RGB brightness is set to 0. The LED status
display shows SH when the shutter is in either black or white modes.

Function Key

In a Numeric Field in a Menu: Use FUNC to enter a negative number.
In a Text Field: Press FUNC followed by:
• the UP arrow key or DOWN arrow key to convert between capital and lowercase letters.
• the LEFT arrow key or RIGHT arrow key to insert or delete a character.
• the ENTER to delete all characters.
Within a Presentation: Press FUNC followed by 2 numeric numbers to
enable a specific color or colors in the display (see right). For example,
will display only red, and
Eliminating one or more colors can help with certain diagnostics and setups,
such as when accurately overlaying one image on top of another from stacked
projectors.
NOTE: Color enabling can also be implemented from numerous locations
within the menu system.
Press F followed by H
UNC
will disable the features without changing the settings associated with them.

Proj

Press P to access a specific projector within a group of projectors or to confirm if the local projector is
ROJ
listening. The number in the "Enter Number" window indicates which projector is currently listening to
commands and will match the projector address defined in the Configuration > Communications menu. The
Proj check box (read-only) shows whether or not the projector physically connected to a remote is listening to
commands from that remote. A checkmark means that connected projector is listening; if there is no
checkmark, you are communicating with a different projector.To control a specific projector with the keypad,
press P and then enter the 3-digit number assigned to the projector you want to use. If you switch to a
ROJ
projector other than the one you are currently using, the checkmark will disappear. To broadcast to multiple
projectors, press P
affect all projectors present.
NOTE: The projector address can be set in the Configuration > Communications menu.

Enter

Press E to select a highlighted item, to toggle a check box, or to accept a parameter adjustment and return
NTER
to the previous menu or image.
3-6
to disable Keystone, Edge Blending and Brightness Uniformity settings. This
ELP
and then P again without entering a projector number. Keypad commands will then
ROJ ROJ
will display green data.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
Figure 3-1 Function Key
020-100367-05 Rev. 1 (06-2012)