Christie Entero RPMWU User Manual page 207

(VST) VERTICAL STRETCH
CONTROL GROUP:
DESCRIPTION
Use Vertical Stretch to adjust the height of the image while keeping the width constant. This controls how much
the image is electronically stretched vertically. As it does not affect the horizontal width, it changes the aspect
ratio of the image. 1000 is the neutral position where no stretching is done.
Vertical Scale = (VST-Value / 1000) * (SIZ-Value / 1000).
SUBCODE
<No Subcode >
EXAMPLES:
(VST 500) - Set vertical stretch to 500 on main video.
(VST?) - Returns the vertical stretch value on main video.
(WRP) WARP / KEYSTONE
CONTROL GROUP:
DESCRIPTION
This serial command will control the writing and reading of 2D keystone maps, warp maps, edge-blend map,
uniformity maps and associated parameters.
The commands below are used from the OSD only, and are not highly applicable for use from Serial
NOTE:
Commands. If they are set, they will only be applied on Power up or if applying them from the OSD.
WRP cannot be used if TIL is enabled.
NOTE:
SUBCODE
SLCT
HKST
VKST
KRST
KTLH
KTLV
KTRH
KTRV
KBLH
KBLV
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(6-2012)
Input Power Down
SUBCLASS:
Configuration/Unsaved
Appendix D: Serial Command Reference
ACCESS LEVEL:
DESCRIPTION OF USE
Set the vertical stretch for the main image.
Power Up
SUBCLASS:
DESCRIPTION OF USE
Select Warping mode:
0 = disabled
1 = 2D keystone
2 = TWIST maps
1D Horizontal keystone adjust
1D Vertical keystone adjust
Reset keystone settings to zero
2D keystone adjust (Top-Left H-position)
2D keystone adjust (Top-Left V-position)
2D keystone adjust (Top-Right H-position)
2D keystone adjust (Top-Right V-position)
2D keystone adjust (Bottom-Left H-position)
2D keystone adjust (Bottom-Left V-position)
Operator
Operator
ACCESS LEVEL:
D-73