Optimizing The Projectors For The Source - Christie Entero RPMWU User Manual

Section 2: Setting Up a Source
2.4

Optimizing the Projectors for the Source

1. Select Image Orientation in the Configuration > Output Settings menu, and change the orientation of
the displayed image to suit the installation. For example, for Christie cube installations, select Rear
Projection Inverted.
2. Assign a unique projector ID number for each projector.
3. If the projectors are connected serially, enable Broadcast Key in the Communications menu. This allows
you to switch between communicating with one or all projectors.
4. Display the source to optimize.
5. Select Auto Setup to give the projector a chance to setup the best possible settings for the chosen
incoming signal.
6. Make sure that the Processing Mode (Image Settings menu) is correct for the selected source.
7. Change Resize Presets if you want the image displayed at a resolution other than native.
8. For analog sources, adjust Pixel Phase and Pixel Tracking from the Size and Position menu to eliminate
noise from the displayed image.
9. ArrayLOC automatically adjusts projector colors and brightness. Ensure that ArrayLOC is enabled.
10. If required, adjust image Blacklevels and Input Levels.
11. If required, optimize Projector Color and Brightness, see
12. If required, adjust brightness uniformity, see
2-6
Managing Colors with ArrayLOC on
Adjust Brightness Uniformity on
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
page-3-55.
page-3-40.
020-100367-05 Rev. 1 (06-2012)