Christie Entero RPMWU User Manual page 139

(AGC) AUTOMATIC GAIN CONTROL (Cont'd)
MAIN
PIIP
EXAMPLES:
(AGC 1) - Enable AGC on main video.
(AGC+MAIN 0) - Disable AGC on main video.
(AGC+PIIP 1) - Enable on PIP video.
(AGC?) - Returns the current AGC state on main video.
(AGC+PIIP ?) - Returns the current AGC state on PIP video.
(AGC+IN12 ?) - Returns the current AGC state on Slot 1 Input 2.
(AIC) AUTO INPUT CYCLING
CONTROL GROUP:
DESCRIPTION
When enabled, the system will continually search for the next valid signal when no signal is present or when loss
of sync occurs on the current user selected Input. In the case of multiple signals to choose from, the order is based
on Slot, followed by Inputs on that Slot.
SUBCODE
<No Subcode >
EXAMPLES:
(AIC 0) - Disable auto Input cycling.
(AIC 1) - Enable auto Input cycling.
(AIL) AUTO INPUT LEVEL
CONTROL GROUP:
DESCRIPTION
If enabled, this control allows the projector to continuously monitor the Input signal levels of the analog Inputs
and make adjustments as needed. Whenever the projector detects a level that would lead to the crushing of black
or white levels, it adjusts the Input offset or gain to compensate. If the Input signal is not being crushed, the
projector will do nothing. The Auto Input Level feature should only be used when the current source requires
further Input level adjustment. There must be at least 12 consecutive white pixels in the image in order to use Auto
Input Levels. The monitor period will run for 10 seconds after being issued. Auto setup or source switching will
stop the level period. To use this control, turn the Auto Input Level feature ON, wait for the blacklevel and drive
values to stabilize, and turn the Auto Input Level feature off or wait for the 10 seconds. When the Auto Input
Level feature is turned OFF, the current drive and blacklevel values are maintained. This control only applies to
analog BNC or Dual DVI cards.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(6-2012)
Preference
SUBCLASS:
Unsaved
SUBCLASS:
Set automatic gain control on main image.
Set automatic gain control on main image.
Power Down
ACCESS LEVEL:
DESCRIPTION OF USE
Enable or disable auto Input cycling.
Power Up
ACCESS LEVEL:
Appendix D: Serial Command Reference
Operator
Operator
D-5