Diagnostics & Calibration - Christie Entero RPMWU User Manual

On each projector you must set the following:
• The tiling array size sets the total rows and total columns. This setting will be the same on all the projectors
in the array.
• The relative location of the projector within the array sets the row number and column number for each
projector
• Tiling can be enabled or disabled by selecting the Tiling Setup check box and you will not lose any of the
above settings.
The features that act differently when Tiling is enabled are:
• The PIP border is disabled.
• Cascading menus are turned OFF.
• Menus show only 5 items, with a scroll bar to allow the rest of the menu items to be reached.
• Keystone and Warp are not supported with Tiling enabled.
• Projector source switching in the array is not synchronized. Therefore some latency can be seen from when
the commands are issued to each projector, causing switching to not be as seamless when in a tiling
configuration.
NOTE: When the FUNC+HELP key combination is pressed, the tiling settings will be cleared.
Tiling and Frame Lock Issues
If, while using tiling, you find that some screens are displaying black when they should be displaying
content, you may need to turn the frame lock feature off or increase the frame delay settings.
To turn the frame lock off, go to the Configuration > Output Options menu and select Free Run from
the Frame Locking drop-down list. You can also use the serial API command (FLE 0).
To increase the frame delay setting, navigate to the Configuration > Output Options menu, select Frame
Lock from the Frame Locking drop-down list, and then drag the Set Frame Delay slider across to a value
slightly higher than the minimum value shown in the Actual Frame Delay field. You can also use the
serial API command (FRD+STAT?) to query for minimum frame lock setting and then use (FRD nnn)
where nnn is slightly higher than the minimum value returned.
Diagnostics & Calibration
Test Pattern
Choose the desired internal test pattern to
display, or select Off to turn off a test
pattern. Alternatively, use the T
cycle through test patterns.
Grey Level
Set the level of grey to display in the full
grey field test pattern.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)
key to
EST
Section 3: Operation
3-45