Arrayloc Menu - Christie Entero RPMWU User Manual

Section 3: Operation

ArrayLOC Menu

Use this menu to set up your projector array color and
brightness.
By default, ArrayLOC is enabled and configured to
automatically display a moderately saturated gamut at the
maximum brightness the array can support. If array colors
must be adjusted or if an individual projector must be
matched to the array, see
ArrayLOC, on page
NOTE: While working in the ArrayLOC menus and
submenus, ArrayLOC displays a warning popup on the
affected projector if adjusted settings fall outside the range
the system can adjust for. Warnings include:
• Minimum brightness not met (BCLOC disabled)
• Minimum brightness not met (Warning)
• Min Gamut not met (BCLOC disabled)
• Min Gamut not met (Warning)
Synchronize to this Projector
To broadcast the ArrayLOC settings to the projectors in your array, you must define a projector as the
"master" by checking the option Main Menu > Configuration > ArrayLOC > Synchronize to This
Projector.
The master projector has access to most settings under the Bright/ColorLOC Configuration and Array
Color Target submenus. These settings are greyed out on the other projectors in the array to prevent
conflicting information from being sent to the array.
You can change which projector is the master at any time, by checking the Synchronize to This Projector
option on another projector. The previous master projector automatically releases the setting.
Bright/ColorLOC Configuration
Use the Bright/ColorLOC Configuration menu to assess and
work with the capabilities of the projectors in the group or
array.
Minimum Brightness
Use this option to set the minimum brightness (as a
percentage of the target brightness) that the array will
target, and to set the threshold for alerts from projectors that
cannot achieve the specified minimum. Projectors that fall
below the minimum are excluded from the calculations of
the common gamut and common brightness.
If the projector falls below the minimum, the projector operates at its current brightness and gamut.
Changes will not be made.
Minimum Gamut
Use this option to set the minimum gamut (as a percentage of the target gamut) that the array will display,
and to set the threshold for alerts from projectors that cannot achieve the specified minimum. Projectors
3-48
Managing Colors with
3-55.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)