Christie Entero RPMWU User Manual page 140

Appendix D: Serial Command Reference
(AIL) AUTO INPUT LEVEL (Cont'd)
SUBCODE
MAIN
PIIP
EXAMPLES:
(AIL 1) - Perform auto Input level on the main image.
(AIL+PIIP 1) - Perform auto Input level on the PIP image.
(ALT) ACTIVE LOOP-THROUGH
CONTROL GROUP:
DESCRIPTION
In situations where a Twin HDMI Input card is being used to loop signals out to another projector, this feature
ensures that video signals continue to be looped out when the projector enters Standby power mode. Note that
when the projector is in Standby mode (and this feature is enabled), limited channel control is available - inputs
can be switched, can perform Auto Setup and some limited input settings can be modified
SUBCODE
<No Subcode >
EXAMPLES:
(ALT 1) - Enable Standby active loop-through.
(ALT 0) - Disable Standby active loop-through.
(ALT?) - Get the current Standby active loop-through setting.
(APJ) ACTIVE PROJECTOR
CONTROL GROUP:
DESCRIPTION
Temporarily enable or disable the IR and wired keypad Inputs to a specific projector in a network of projectors.
When a projector is disabled, the only key that works is PROJ. The next time the projector is powered up again, it
will revert to fully enabled. The built-in keypad will always be fully functional. This control does not overwrite
the Front IR, Back IR and Wired Keypad settings.
SUBCODE
<No Subcode >
EXAMPLES:
(APJ 1) - Projector is active (keypads are enabled).
(APJ 0) - Projector is not active (keypads are temporarily disabled).
(APJ?) - Is the projector keypad active or not.
D-6
Preference
SUBCLASS:
Input Power Down
SUBCLASS:
DESCRIPTION OF USE
Perform auto Input level on the main image.
Perform auto Input level on the PIP image.
Power Down
ACCESS LEVEL:
DESCRIPTION OF USE
Enable or disable active loop-through.
ACCESS LEVEL:
DESCRIPTION OF USE
Set 0 to temporarily disable keypad access to this projector.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
Operator
.
Operator
020-100367-05 Rev. 1 (6-2012)