Christie Entero RPMWU User Manual page 151

(CCS) SELECT OUTPUT COLOR
CONTROL GROUP:
DESCRIPTION
Selects which of several predefined and 4 user defined color maps to use for a specific Input signal.
0 = MaxDrives - All color adjustments are turned off allowing the projector to run at maximum brightness.
1 = Color Temperature - This will allow you to specify a color temperature between 3200 and 9300 based on the
setting of the Color Temperature control. Color temperature is expressed in degrees Kelvin [3200, 5400, etc.].
Lower numbers give a reddish white, higher numbers appear bluish. There are 4 standard settings. 9300K is close
to the white of many computer monitors. 6500K is the standard for color video, in both standard- and high-
definition forms. 5400K is a standard for graphics and black-and-white video. 3200K is useful if the projected
image is to be filmed or shot as part of a studio set that is illuminated with incandescent lights. For all color
temperatures, the color primaries [red, green & blue] are unchanged and reflect the native colors of the projector.
2 = SD Video - Optimized for SD video. This will allow you to adjust the color of red, green and blue, as well as
the color white.
3 = HD Video - Optimized for HD video. This will allow you to adjust the color of red, green and blue, as well as
the color of white.
4 = User 1 - Selects a user defined sets of color adjustments.
5 = User 2 - Selects a user defined sets of color adjustments.
6 = User 3 - Selects a user defined sets of color adjustments.
7 = User 4 - Selects a user defined sets of color adjustments.
The set of 4 User Defined settings are defined in the configuration menu.
SUBCODE
INxy
MAIN
PIIP
EXAMPLE:
(CCS 0) - Set the color temp setting to max drives for main video.
(CHA) CHANNEL
CONTROL GROUP:
DESCRIPTION
Select the channel to use, in the range 1-99. Switching channels will switch to the appropriate option card/Input. If
the signal signature in the channel does not match the signal on the channel's Input, the channel change will switch
to the "auto-channel" or to the channel that was defined for the signal signature that is on the channel's Input. This
command will fail if the data in the channel file does not match the current system hardware. This command can
also be used to copy, delete and edit certain channel properties.
SUBCODE
COPY
DLET
MAIN
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(6-2012)
Input Power Down
SUBCLASS:
Unsaved
SUBCLASS:
ACCESS LEVEL:
DESCRIPTION OF USE
Select the color temp setting for Slot x, Input y.
Select the color temp setting for main video.
Select the color temp setting for PIP video.
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
Make a copy of a channel, and assign it a unique number
(optionally, specify a new channel number).
Delete a channel.
Set the channel being used by main.
Appendix D: Serial Command Reference
Operator
Operator
D-17