Installing A Lens, Lamp And Cooling; Install Lens(Es); Primary Lens; Auxiliary Lens Installation (Optional) - Christie CP2000-XB Setup Manual

Section 2: Installation & Setup
2.4

Installing a Lens, Lamp and Cooling

Before or after you have positioned the projector in its permanent or temporary location, install the remaining
components: the lens, lamp and external extractor fan.

2.4.1 Install Lens(es)

Primary Lens

1. Fully insert the assembly straight into the lens mount opening all the way back without turning.With the
lens fully back, it will seat properly within the lens mount. NOTE: High Contrast lenses (only) have a flat
on the rear flange. Rotate the lens so that the flange clears two screws in the mount. Also ensure that the
UP label is at the top to ensure proper aperture orientation.
2. Lock the lens assembly in place with lens clamp DOWN.
3. Secure lens safety ring, and tether to projector (not required if projector is floor-mounted). NOTE: The
lens seals the projector head, preventing contaminants from entering the area of main electronics. Never
attempt to operate the projector without a lens installed.

Auxiliary Lens Installation (Optional)

NOTE: The optional auxiliary lens mount is required for use of the 1.25x anamorphic or 1.26x Wide Converter
lens, producing 2.39:1 scope images.
If the auxiliary lens will be used, it is recommended that you add the lens—and its mount—before final
leveling, boresight adjustment and the like. Install only for those installations requiring full-size 2.39:1 scope
display (mostly side-masking screens) obtained by optically stretching a pre-squeezed image.
INSTALL THE AUXILIARY LENS MOUNT ON THE PROJECTOR: At the front of the projector,
install the auxiliary lens mount hardware as described in the instructions provided with Christie's Auxiliary
Lens Mount Kit.
INSTALL THE 1.25x ANAMORPHIC or 1.26x WIDE CONVERTER LENS: Clamp the 1.25x
anamorphic or 1.26x Wide Converter lens mount in place, following the instructions provided with the
auxiliary lens mount kit.

2.4.2 Install First Lamp

Remove the lamp door and open the empty lamp-cooling compartment.
2-14
1) Protective gear required. 2) Qualified service technician required.
Figure 2-21 Open Lamp Door and Cooling Compartment
CP2000-XB Setup Guide
020-100250-02 Rev. 1 (06-2009)