Install Primary Zoom Lens; Install Anamorphic Lens - Christie CP2210 User Manual

Section 2: Installation and Setup
2.7

Install Primary Zoom Lens

1. Turn the lens clamp to the OPEN position
(Figure 2-6).
2. Remove the two hex screws from the lens mount
(Figure 2-7).
3. Orient the lens so the lens retaining ring mounts line
up with the lens mount. Fully insert the assembly
straight into the lens mount opening without turning
(Figure 2-6). Magnets, mounted inside the lens mount,
help to properly guide the lens. When you hear a
tapping sound it indicates the lens has made contact
with the magnets. These magnetic guides ensure the
lens is properly seated inside the mount, that the
aperture is orientated correctly and that the connector
for motorized zoom and focus is properly connected.
4. Secure the two hex screws and position the lens clamp
DOWN to lock the lens assembly in place (Figure 2-7).
2.8

Install Anamorphic Lens

1. Install the M-MALM according to the instructions provided with the kit. Ensure the primary lens is
optimized first for best optical alignment, offset and boresight.
2. Anamorphic orientation: Loosen the holding clamp on the auxiliary lens mount and adjust rotation of the
whole anamorphic lens so the image remains perfectly square with anamorphic in and out.
3. Image shift: Adjust location of anamorphic lens so the image does not shift left or right with the
anamorphic lens IN and OUT.
4. Vignetting: Adjust location of anamorphic lens so the image passes through the center as much as possible
without vignetting or reducing side or corner brightness, especially in wide angle projection.
2-8
Downloaded from ProjectorsManual.com Manuals
The lens prevents containments from entering the projector.
Figure 2-7 Lock Lens in Place
Figure 2-6 Insert Lens
CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)