Christie Entero RPMWU User Manual page 55

Network Routing
NOTE: Not applicable for stand-alone projectors or simple serial networks with only one type of controller
and linking.
Separate
Select "Separate" (factory default) to keep RS-232, RS-422 and Ethernet messages on their respective
paths instead of being broadcast to the other types of ports.
RS-232 and RS-422 Joined
Messages originating from an RS-232 or RS-422 controller will be relayed to all RS-232 or RS-422 ports.
Any Ethernet communication, however, will not.
RS-232 and Ethernet Joined
Messages to and from the RS-232 ports will also be relayed to the Ethernet port, and vice versa. Any RS-
422 communications will be isolated. In the case of multiple Ethernet sessions over the single Ethernet
connector, input on the RS-232 port will be relayed to all Ethernet sessions; however, input from any
Ethernet session will only be relayed to the RS-232 ports.
All Joined
All messages reach all ports, regardless of type in the case of multiple Ethernet sessions, input on one
Ethernet session will be relayed to all other Ethernet sessions as well as to the RS-232 and RS-422 ports.
Ethernet Settings
NOTE: Recommended for network administrators only.
IP Address
Enter a valid and unique IP address for use on the network to which the projector is currently connected.
This address will overwrite any previous IP address such as the factory-defined projector default. It takes
approximately 10 seconds for the projector to respond at its new address.
TCP Port
On some Ethernet networks, firewall restrictions may require that the port number of the projector be
changed from its default of 3002. If so, enter a new valid port number here. It is highly recommended not
to use a port number below 1000, as these ports are typically reserved for and used by common IP
applications.
Subnet Mask
Subnet Mask determines the subnet for the IP address, and must be set manually.
Default Gateway
This is the IP address of the gateway used to reach any non-local IP addresses, and it must be set manually.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)
Figure 3-9 Network Routing List
Section 3: Operation
3-35