Power Management - Christie Entero RPMWU User Manual

NOTE: Frame locking on projectors in a ArrayLOC network can be controlled from one projector. See
Synchronize Frame Delay on
frame delay for the synched projectors in the array.
Actual Frame Delay
iIndicates the dynamically calculated, effective minimum frame delay for the projector. The calculated delay is
affected by image shift, scaling, warp/keystone applied, and format. For example, the minimum latency can
vary based on the amount of scaling applied to the image. When using keystone or warping, an additional
latency is required, depending on the amount of warp.
Free Run Frequency
This control sets the output video vertical frequency when Frame Locking is set to Free Run.
HDMI Output Loop Source
The HDMI output options are:
• Choose Direct Loop to directly pass-through the HDMI input signals from the same Twin HDMI input card.
The Input1 signal is looped to Output1, and the Input2 signal is looped to Output2.
• Choose Main/Secondary Loop to loop the main & Secondary video to the outputs regardless of which card
these signals originate from. The main video signal is looped to Output1, and the secondary video signal is
looped to Output2.

Power Management

Auto Power Up
If there is an AC power interruption, while Auto Power Up is enabled, the projector will resume operation in
the same state as it left off. If the light engine is ON and an image is showing when AC power is lost, the
projector automatically powers back up with the light engine ON and an image will show when AC is restored.
Auto Shutdown Enable
When AUTO SHUTDOWN Mode has been selected, and no projector activity has been seen for the activation
time-out period, the projector will enter a power saving mode in which the light engine dims and the shutter
closes. If this condition persists for an additional time-out period, the projector automatically goes into
STANDBY mode. The presence of any activity within this combined interval will cancel Auto Shutdown and
will return the projector to normal operation.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (06-2012)
page-3-55. When Synchronize Frame Delay is used, the master projector sets the
Section 3: Operation
3-31