Christie Entero RPMWU User Manual page 162

Appendix D: Serial Command Reference
(FLE) FRAME LOCK ENABLE
CONTROL GROUP:
DESCRIPTION
This control enables or disables Frame Lock, which controls how the projector controls the output frame timing
based on the Input signal. When set to Frame Lock, output image frames are locked to the Input if possible. When
locked, the output is always locked to the primary Input, never the PIP image. Free Run sets the output to close to
60Hz for all sources. This control must be set to locked if a 3D-Stereo signal is used.
SUBCODE
<No Subcode >
EXAMPLES:
(FLE 0) - Free Run output.
(FLE 1) - Enables frame lock.
(FLE ?) - Get frame lock enabled status.
(FLW) SERIAL FLOW CONTROL
CONTROL GROUP:
DESCRIPTION
Set the flow control for a serial communications port.
SUBCODE
PRTA
PRTB
PRTC
EXAMPLES:
(FLW+PRTA 0) - Set no flow control on port A.
(FLW+PRTA 1) - Set flow control on port A to software.
(FLW+PRTA?) - Get flow control (FLW+PRTA!001 "Software")
(FMD) FILM MODE DETECT
CONTROL GROUP:
DESCRIPTION
Enable or disable film motion detection. This is only available for interlaced or segmented frame sources. Valid
values are:
0 = Disabled
1 = Auto
2 = PsF
SUBCODE
INxy
D-28
Preference
SUBCLASS:
Preference
SUBCLASS:
Input Power Up
SUBCLASS:
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
Enables or Disables frame lock.
Power Down
ACCESS LEVEL:
DESCRIPTION OF USE
Set the mode on port A (RS-232 IN).
Set the mode on port B (RS-232 OUT).
Set the mode on port C (RS-422).
ACCESS LEVEL:
DESCRIPTION OF USE
Set the film mode detect for Slot x, Input y.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
Operator
Advanced
Operator
020-100367-05 Rev. 1 (6-2012)