Christie Entero RPMWU User Manual page 135

Appendix D: Serial Command Reference
(ABL) ARRAY BRIGHT COLOR LOC
CONTROL GROUP:
DESCRIPTION
This command is used to set parameters that control how the Array Bright/ColorLOC feature operates. From this
control you enable the mode in which you want to operate the feature: target brightness, target gamut, update
intervals, and other miscellaneous parameters.
SUBCODE
EABL
BRGP
BRTG
MINB
MING
ADIN
BRIN
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1 (6-2012)
Preference
SUBCLASS:
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
Enable Array Bright/ColorLOC:
0 = OFF
1 = fixed mode (uses CCA only)
2 = cool mode (uses CCA and LED control)
3 = bright mode (uses CCA and multi LED control)
Brightness Group. Identifies a subset of all projectors in the
array to be used in the Array BCLOC algorithm. May be used
to provide multiple groups of projectors with different color
targets. (0-9999)
Brightness Target. Sets the target brightness that the projectors
in the array brightness group should meet. (0-1000 Lumens)
Minimum Brightness. Sets the minimum brightness, as a
percentage of target brightness, that the projector will display
if it is capable. (0-100 percent)
Minimum Gamut. Sets the minimum gamut, as a percentage of
the target gamut, that the projector will display if it is capable.
(0-100 percent)
Adjustment interval. Controls the interval in seconds that this
projector will run the Array Bright/ColorLOC algorithm. (1-
9999)
Broadcast interval. Controls the interval in seconds that this
projector will update the projector array. (1-9999)
Operator
D-1