Christie Entero RPMWU User Manual page 193

(RTE) REAL TIME EVENTS (Cont'd)
0 = Boot Up
1 = Power ON/OFF
T = 0 (Either a Power ON or OFF event)
T = 1 (Power ON only)
T = 2 (Power OFF only)
GPIO Events:
(RTE G "AAAAAAA" "description" "command")
where A is GPIO Input for each pin:
= X (don't care)
= H (when pin is high) - See
= L (when pin is low) - See
Delete All Events:
(RTE X *)
Delete a single event:
(RTE X A), where A is the event to be deleted (0-??)
SUBCODE
<No Subcode >
EXAMPLE:
Single Occurrence Events:
(RTE T 2008/12/25 11:48:00 S "description" "(LSH 1)") - close the shutter at 11:48:00 on December 25, 2008
(RTE T 2009/01/01 23:00:00 S "description" "(CHA 2)") - switch to channel 2 on January 1, 2009 at 23:00:00
Daily Occurring Event:
(RTE T 2009/01/01 23:00:00 2009/02/01 D 1 "description" "(PWR 1)") - power on the projector every day at
23:00:00, starting from January 1, 2009 until February 1, 2009
(RTE T 2009/01/01 23:00:00 2009/02/01 D 2 "description" "(PWR 1)") - power on the projector every other day
at 23:00:00, starting from January 1, 2009 until February 1, 2009
(RTE T 2009/01/01 23:00:00 2009/02/01 D 5 "description" "(PWR 1)") - power on the projector every fifth day at
23:00:00, starting from January 1, 2009 until February 1, 2009
Weekly Occurring Event:
(RTE T 2009/01/01 23:00:00 2009/03/01 W 1 "SSu" "description" "(PWR 0)") - power off the projector every
week, on Saturday and Sunday at 23:00:00, starting from January 1, 2009 until March 1, 2009 (inclusive)
(RTE T 2009/01/01 23:00:00 2009/03/01 W 2 "MTWThF" "description" "(PWR 1)") - power on the projector
every other week, on every weekday at 23:00:00, starting from January 1, 2009 until March 1, 2009 (inclusive)
(RTE T 2009/01/01 23:00:00 2009/03/01 W 5 "MTWThF" "description" "(PWR 1)") - power on the projector
every fifth week, on every weekday at 23:00:00, starting from January 1, 2009 until March 1, 2009 (inclusive)
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(6-2012)
2 = Any System Error
3 = Good Signal
4 = No Signal
5 = Input Change
6 = Channel Change
T = channel (where channel is 1-99)
(GIO) General Purpose Input/Output on page D-31
(GIO) General Purpose Input/Output on page D-31
DESCRIPTION OF USE
Appendix D: Serial Command Reference
D-59