Install The Lens - Christie Matrix StIM-WQ User Manual

Installation Procedures

Install the Lens

è è
C AU TI O N /
R i sk G r oup 2/ q³I§ q³I§
Possi bl e hazar dous opt i cal r adi at i on
em i t t ed f r om t hi s pr oduct .
,§ÁïýÑúqi„I
D o not st ar e at oper at i ng l am p.
M ay be har m f ul t o t he eyes.
÷ÿ ÝÆå\-„oˇ ï ý$³¨„<[ ÷ÿ ÝÆå\-„oˇ ï ý$³¨„<[
Failure to comply with the following may result in equipment damage:
• Do not insert the lens at an angle.
• Always replace the lens plug when transporting to protect the optical components.
• Always place the lens cap onto the lens when transporting to avoid scratching the lens.
• Never operate the projector without a lens.
• A small amount of dust or dirt on the lens has minimal effect on image quality. To avoid the
risk of scratching the lens, clean only if absolutely necessary. See
page 73.
1. Remove the lens plug from the lens opening.
2. Remove the rear lens cap from the lens.
3. Rotate the lens clamp to the open position.
4. Remove and retain the (2) security screws from the lens mount.
5. Align the lens interface plate with the lens mount. Fully insert the assembly straight into the lens
mount opening without turning.
6. Rotate the lens clamp to the closed position before fastening the security screws.
Security screw
Lens clamp
(closed position)
8
Risk Group 2: Possible hazardous optical radiation emitted from this product.
Do not stare at operating lamp. May be harmful to the eyes. Failure to comply
2 2
could result in minor or moderate injury.
For some installations security screws are required on the lens.
Cleaning the Lens
Security screw
Matrix StIM™ WQ/SIM WQ User Manual
020-100883-01 Rev. 2 (06-2013)
on