Christie Entero RPMWU User Manual page 163

(FMD) FILM MODE DETECT (Cont'd)
MAIN
PIIP
EXAMPLE:
(FMD 1) - Enable Auto Film mode detect for Main video.
(FRD) FRAME DELAY
CONTROL GROUP:
DESCRIPTION
Delays the output signal timing relative to the Input signal timing by a fraction of a frame, and up to several
frames. The minimum latency can vary based on the amount of scaling applied to the image. When using keystone
or warping, an additional latency is required, depending on the amount of warp. The control is only available
when the Input signal is frame locked. In free run mode, or in cases where the signal cannot be frame locked, the
minimum latency defined by the scaling and keystoned/warp is applied to the signal. The value used is a 1/1000th
of a frame. For example, 1000 equals 1 frame.
SUBCODE
STAT?
EXAMPLES:
(FRD 1500) - Delay 1.5 frames.
(FRD+STAT?) - Retrieve the actual minimum frame delway.
(FRF) FREE RUN FREQUENCY
CONTROL GROUP:
DESCRIPTION
This controls sets the output video vertical frequency.
SUBCODE
<No Subcode >
EXAMPLES:
(FRF 5000) - Set free run frequency to 50 Hz.
(FRF ?) - Get free run frequency.
(FRZ) FREEZE IMAGE
CONTROL GROUP:
DESCRIPTION
Freeze the display image. This allows a detailed examination of a single frame of an otherwise moving image.
Switching channels/Inputs automatically switches the projector to unfrozen.
Entero RPMWU/RPMSP/RPMHD-LED01 User Manual
020-100367-05 Rev. 1(6-2012)
Preference
SUBCLASS:
Preference
SUBCLASS:
Unsaved
SUBCLASS:
Set the film mode detect for Main video.
Set the film mode detect for PIP video.
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
Retrieve the actual minimum frame delay.
Power Up
ACCESS LEVEL:
DESCRIPTION OF USE
Set the output vertical frequency, used when running in "Free
Run" mode. Refer to
Power Up
ACCESS LEVEL:
Appendix D: Serial Command Reference
Operator
Operator
(FLE) Frame Lock Enable.
Operator
D-29