Set Spantree Portvlanpri; Set Spantree Priority - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Access: Enabled.
Examples: The following command changes the cost on ports 3 and 4 to 20 in VLAN mauve:
DWS-1008# set spantree portvlancost 3,4 cost 20 vlan mauve
success: change accepted.

set spantree portvlanpri

Changes the priority of a network port or ports for selection as part of the path to the STP
root bridge, on one VLAN or all VLANs.
Syntax:
port-list
priority
value
all
vlan vlan-id VLAN name or number. MSS changes the priority
Defaults: The default STP priority for all network ports is 128.
Access: Enabled.
Examples: The following command sets the priority of ports 3 and 4 to 48 on VLAN mauve:
DWS-1008# set spantree portvlanpri 3-4 priority 48 vlan mauve
success: change accepted.

set spantree priority

Changes the STP root bridge priority of a switch on one or all of its VLANs.
Syntax: set spantree priority value
priority
value
all
D-Link Systems, Inc.
set spantree portvlanpri port-list priority value
List of ports. MSS changes the priority on the
specified ports.
Priority value. You can specify a value from 0
(highest priority) through 255 (lowest priority).
Changes the priority on all VLANs.
on only the specified VLAN.
Priority value. You can specify a value from
0 through 65,535. The bridge with the lowest
priority value is elected to be the root bridge for
the spanning tree.
Changes the bridge priority on all VLANs.
all vlan vlan-id
{ | }
STP Commands
all | vlan vlan-id
{ }
238