Set Prompt - D-Link DWS-1008 Cli Reference Manual

DWS-1008 CLI Reference Guide
Examples: To set the number of lines displayed to 100, type the following command:
DWS-1008# set length 100
success: screen length for this session set to 100

Set Prompt

Changes the CLI prompt for the DWS-1008 switch to a string you specify.
Syntax: set prompt string
string
Defaults: The factory default for the switch name is DWS-1008-nnnnnn, where nnnnnn is the
last 6 digits of the 12-digit system MAC address.
Access: Enabled
Usage: When you first log in for the initial configuration of the switch, the CLI provides an
DWS-mm-nnnnnn> prompt. After you become enabled by typing enable and giving a suitable
password, the DWS-1008-nnnnnn# prompt is displayed. If you use the set system name
command to change the default system name, MSS uses that name in the prompt, unless
you also change the prompt with set prompt.
Examples: The following example sets the prompt from DWS-1008 to happy_days:
DWS-1008# set prompt happy_days
success: change accepted.
happy_days#
D-Link Systems, Inc.
Alphanumeric string up to 32 characters long. To include spaces in the prompt,
you must enclose the string in double quotation marks ("").
System Services Commands
17