Configure Igmp - Extreme Networks ExtremeWare Command Reference Manual

configure igmp

configure igmp <query interval> <query response interval> <last member
query interval>
Description
Configures the Internet Group Management Protocol (IGMP) timers.
Syntax Description
query interval
query response interval
last member query interval
Default
• query interval—125 seconds
• query response interval—10 seconds
• last member query interval—1 second
Usage Guidelines
Timers are based on RFC2236. Specify the following:
• query interval—The amount of time, in seconds, the system waits between sending out general
queries. The range is 1 to 429,496,729 seconds.
• query response interval—The maximum response time inserted into the periodic general queries.
The range is 1 to 25 seconds.
• last member query interval—The maximum response time inserted into a group-specific query sent
in response to a leave group message. The range is 1 to 25 seconds.
Example
The following command configures the IGMP timers:
configure igmp 100 5 1
History
This command was available in ExtremeWare 2.0.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.7 Command Reference Guide
Specifies the interval (in seconds) between general queries.
Specifies the maximum query response time (in seconds).
Specifies the maximum group-specific query response time (in seconds).
configure igmp
2017