Configure Pim Timer Vlan - Extreme Networks ExtremeWare Command Reference Manual

configure pim timer vlan

configure pim timer <hello interval> <join prune interval> vlan [<vlan
name>]
Description
Configures the timers on one or more VLANs.
Syntax Description
hello interval
join prune interval
vlan name
Default
• hello interval—30 seconds.
• join prune interval—60 seconds.
Usage Guidelines
Use this command to configure one or more timers that are associated to each VLAN where PIM is
enabled. If the VLAN name is not specified, the configuration is applied to all the VLANs on which
PIM is enabled.
Example
The following command configures the global PIM timers on the VLAN accounting:
configure pim timer 150 300 vlan accounting
History
This command was first available in ExtremeWare 4.0.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.7 Command Reference Guide
Specifies the amount of time before a hello message is sent out by the PIM
router. The range is 1 to 65,519 seconds.
Specifies the join/prune interval. The range is 1 to 65,519 seconds.
Specifies a VLAN name.
configure pim timer vlan
2043